Laser transmitters

Sviwelling Laser D22

Laser transmitter with swivelling head for 360° sweep of the laser beam.
The sweep can be leveled to a horizontal or vertical plane. The beam can be deflected 90° to the sweep.
Straightness, flatness, squareness, parallelism, level and plumb.

Part nr. 12-0022

Spinning laser D23

Laser transmitter with motor-driven rotating head (360°).
(Use with detector D6.)
Straightness, flatness och parallelism.


Part nr. 12-0168

Laser transmitter D75

The laser transmitter D75 is used for measurement of straightness and spindle direction.
At the sides M6-threads allow alternative mounting possibilities. This transmitter comes as standard with the extruder, Linebore and Turbine system.
Straightness and plumb.

Part nr. 12-0075

Spindle laser D146

Laser transmitter for measurement of spindle direction and straightness.
Attached to a spindle it will project concentric circles when the spindle is rotated. The centres of those circles are the same as for the pointing direction of the spindle. This allows measurement of the pointing direction of the spindle relative to the movement of the detector, as well as straightness along the spindle direction.
The clamping pin can be mounted at both ends of the transmitter. Pins of different diameters can be used.
Straightness and plumb.


Part nr. 12-0146

Detectors

Detector D5

Detector that can read the position of a laserbeam.
Built-in electronic 360° inclinometer and thermal sensor. A number of threads and mounting holes allow varying attachement possibilities. Vials and target for rough alignment. Two alternative connections for display unit and other detectors. Markings for measurement directions.

Part nr. 12-0005

Detector D6

With SpinLaser Technology™.
Detector that can read the position of a rotating laser beam from the D23 laser transmitter. Built-in electronic 360° inclinometer and thermal sensor. Two alternative connections for display unit and other detectors.

Part nr. 12-0201

Detector D157

Detector that can read the position of a laser beam.
Built-in electronic inclinometer. Housing with eight threads (M5) allow varying attachment possibilities. Two alternative connections for display unit. Markings for measurement directions.

Part nr. 12-0157

Miscellaneous accessories

Printer:

Battery operated thermal printer with cable and charger.

Part nr. 03-0032

Angular prism D46

For 90° deflection of the laserbeam ± 0.01 mm/m.

Part nr. 12-0046